Välj årsmodell för att se om produkten passar din bil.

Ventilation window moldings standing 4 door post

885 kr

These moldings fit the post of 4 doors

SKU: GUM-0868-1 Enhet: couple

Description

The standing ventilation pane strip is the strip that seals against the rear edge of the vent pane glass. The kit contains both the left and right sides of the straight upright part of the sealing strips around the vent window, the angled front part is not included in this kit, it is purchased separately. Look at the picture, the location is marked in red. They only fit 4-door cars that have a post between the front and rear door windows. If you are not sure if these are the right moldings for your car, check the chassis plate under the hood, it says 6219 or 6019 and you have a 4-door pillar, then these are the right moldings for your car.

Tip!

To change the vertical ventilation grid strips, you must also remove the front vertical U-Channel felt strip that the glass of the door glass slides into. Install one side at a time, compare how the other side is installed. Clean off all old putty and rubber residues in the vent window frame. Sand off moldings in the rubber and fine-tune the fit of the new moldings before you start assembling. And the most important tip is as usual. Think first, assemble later.

You may also like…