Generally
A rear wheel bearing of the highest quality. Complete with shrink ring, O-Ring and the packing box that sits together with the bearing. Click on Tips! you receive important information
Välj årsmodell för att se om produkten passar din bil.
Rear wheel bearing complete with shrink ring
1 910 kr
Tip!
Install the bearing the right way, on one side you will see a spring, it is part of the stuffing box. The bearing must be turned so that the spring is inwards, closest to the oil. It comes with an instruction in Swedish how to change the bearing. The picture shows what the bearing should look like after assembly, the arrow points to the spring, which should face the oil and thus be visible
The picture shows what the bearing should look like after assembly, the arrow points to the spring, which should face the oil and thus be visible
Here is an important detail. The pictures show how the ventilation can look up on the rear axle. The red frame shows where the protective plate for the ventilation is located. The blue highlighted part shows where there was an opening before all the old dirt blocked the hole. What happens if it looks like this is that there is an excess pressure in the rear axle when the oil gets hot, and the excess pressure causes oil to be forced out through the rear wheel bearing stuffing box. Check that your vent is open and does not look like the picture.
If you look carefully, there is a small hole in the brake shield, that hole is for the rear axle oil to flow out on the back of the brake shield and not onto the brake shoes in the event of a wheel bearing failure. You must open the small hole on the new gasket. Check where the arrow points in the picture. 
